Author |
Message |
Augie Samba Member
Joined: February 15, 2004 Posts: 160 Location: LI, NY
|
Posted: Wed Jul 27, 2005 10:34 am Post subject: source for bearings |
|
|
My normal suppliers are out of stock on a main bearing set I need, specifically a third linebore with double thrust for a std crank. The number in my book is 111 198 491 60. Anyone know a place I can order these? |
|
Back to top |
|
|
[email protected] Samba Member
Joined: August 15, 2002 Posts: 4394 Location: Brew City
|
Posted: Wed Jul 27, 2005 10:47 am Post subject: |
|
|
I have them in stock, I just checked the shelf. |
|
Back to top |
|
|
sparkmaster1 Samba Member
Joined: February 03, 2004 Posts: 201 Location: Federal Way, WA
|
Posted: Wed Jul 27, 2005 8:14 pm Post subject: |
|
|
New or used?? _________________ Tim's ACVW Engine/Trans Service |
|
Back to top |
|
|
[email protected] Samba Member
Joined: August 15, 2002 Posts: 4394 Location: Brew City
|
Posted: Thu Jul 28, 2005 6:58 am Post subject: |
|
|
I don't stock used bearings. |
|
Back to top |
|
|
Glenn Mr. 010
Joined: December 25, 2001 Posts: 76916 Location: Sneaking up behind you
|
Posted: Thu Jul 28, 2005 7:00 am Post subject: |
|
|
sparkmaster1 wrote: |
New or used?? |
Damn... that's just cruel. _________________ Glenn
74 Beetle Specs | 74 Beetle Restoration | 2180cc Engine
"You may not get what you pay for, but you always pay for what you get"
Member #1009
#BlueSquare |
|
Back to top |
|
|
[email protected] Samba Member
Joined: August 15, 2002 Posts: 4394 Location: Brew City
|
Posted: Thu Jul 28, 2005 7:02 am Post subject: |
|
|
Glenn wrote: |
sparkmaster1 wrote: |
New or used?? |
Damn... that's just cruel. |
Damn.....that is so 4th grade. |
|
Back to top |
|
|
Jake Raby Samba Member
Joined: August 23, 2003 Posts: 7433 Location: Aircooled Heaven USA
|
Posted: Thu Jul 28, 2005 7:03 am Post subject: |
|
|
Hell, sometimes used is BETTER than new!
I built an engine from all used parts to get one of my racers going after a failure- That engine WON 4 races! Even the piston rings were used and were dug out of the dumpster when the new ones that were sent to us were the wrong size!! _________________ Jake Raby
Raby Engine Development
www.rabyenginedevelopment.com
"I've never given anyone Hell, I just told them the truth and they thought it was Hell" |
|
Back to top |
|
|
steel buggin Samba Member
Joined: March 24, 2003 Posts: 415 Location: Arcadia,Ca
|
Posted: Fri Jul 29, 2005 9:31 pm Post subject: |
|
|
I would have to say, Jake, you are right on the money. Sometimes used bearings are better than new, modified bearings. |
|
Back to top |
|
|
|