Author |
Message |
TinCanFab Samba Member
Joined: April 04, 2006 Posts: 2743 Location: Waterford, California
|
Posted: Sat May 20, 2006 12:13 pm Post subject: rear discs |
|
|
hey guys, i have rear cb wide 5 brakes that are not engaging properly. I also have fronts, new metal lines, stainless hoses, new 67 master, etc. What have you guys done to make your rear discs grab properly?? I installed a cnc residual valve but it has pipe thread fittings and leaks when I try to adapt them to the flare fittings! Any suggestions?? I am willing to adapt/ modify any part of the system to keep my front tires from locking up, thanks |
|
Back to top |
|
|
Miguel Arroyo Samba Member
Joined: April 02, 2004 Posts: 3122 Location: Miami Beach, Florida
|
Posted: Sat May 20, 2006 3:05 pm Post subject: |
|
|
I ordered a residual valve from CB Performance when I installed four wheel disc brakes 2 and 1/2 years ago. The brakes have been working great all this time. The only maintenance item I did was to replace the brake fluid 6 months ago. |
|
Back to top |
|
|
btrghia Samba Member
Joined: September 15, 2004 Posts: 190 Location: tucson,az
|
Posted: Mon May 22, 2006 8:10 am Post subject: |
|
|
Miguel Arroyo wrote: |
I ordered a residual valve from CB Performance when I installed four wheel disc brakes 2 and 1/2 years ago. The brakes have been working great all this time. The only maintenance item I did was to replace the brake fluid 6 months ago. |
What check valve are you using? Does it go to the rear or front brakes. |
|
Back to top |
|
|
|