Hello! Log in or Register   |  Help  |  Donate  |  Buy Shirts See all banner ads | Advertise on TheSamba.com  
TheSamba.com
 
Link pin concave washers
Forum Index -> Split Bus Share: Facebook Twitter
Reply to topic
Print View
Quick sort: Show newest posts on top | Show oldest posts on top View previous topic :: View next topic  
Author Message
Campy
Samba Member


Joined: January 10, 2005
Posts: 4933
Location: Chico, CA
Campy is offline 

PostPosted: Mon Nov 13, 2006 12:26 pm    Post subject: Link pin concave washers Reply with quote

Is the concave washer that fits on the end of the trailing arm where the link pin goes through necessary? I picked up an unused albatross frontend for $100 and installed some good, used king pins/spindles and link pins on it but I could only find one or two of the concave washers to use. The other link pins have the rubber O-ring on the link pin directly against the side of the trailing arm (no washer).
Does anyone sell the concave washers that fit on the 1964-1967 model link pins?
Back to top
View user's profile Send private message Gallery Classifieds Feedback
Display posts from previous:   
Reply to topic    Forum Index -> Split Bus All times are Mountain Standard Time/Pacific Daylight Savings Time
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

About | Help! | Advertise | Donate | Premium Membership | Privacy/Terms of Use | Contact Us | Site Map
Copyright © 1996-2023, Everett Barnes. All Rights Reserved.
Not affiliated with or sponsored by Volkswagen of America | Forum powered by phpBB
Links to eBay or other vendor sites may be affiliate links where the site receives compensation.