Author |
Message |
msinabottle Samba Member
Joined: September 20, 2005 Posts: 3492 Location: Denver Area, Colorado
|
Posted: Tue Oct 15, 2013 7:17 pm Post subject: A Bit More Clarification |
|
|
A person doing the same drill (or is that, 'route?') asked for some more details, thought I'd share them.
--
What we did was to cut a length of wood, about an inch in width, to a bit more than the diameter of the front (I have an '84) axle end cups, and round that on the ends, keeping the length correct. I bought a carbide downthrust router bit, wore a face shield and a shop apron, and just kept going around and around the central hole. I put the rim on a trash can to catch the shavings.
As I got more and more material out, I used the gauge to see if I was there yet, didn't stop until I could turn it around the hole. I did all four rims so I wouldn't have to worry about which went were. One mistake I hope you can avoid is that I didn't 'taper' the hole. The axle end cap tapers, so your hole can do the same, I made mine uniform to the end of the bore and in spots on two of the hubs went through the outer molding. I patched that successfully, but there was no need to do so.
--
Rims and my repairs are holding up beautifully.
Best! _________________ 'Winston,' '84 1.9 WBX Westy
Vanagon Poet Laureate: "I have suffered in
many ways, but never, never, never in silence." |
|
Back to top |
|
|
dobryan Samba Member
Joined: March 24, 2006 Posts: 16501 Location: Brookeville, MD
|
|
Back to top |
|
|
msinabottle Samba Member
Joined: September 20, 2005 Posts: 3492 Location: Denver Area, Colorado
|
Posted: Tue Oct 15, 2013 7:37 pm Post subject: Embarassment! |
|
|
Okay, I TRIED to do the right thing, so when it looked like I'd double-posted, I deleted what I thought was the 2nd post of the July 2008 post and it was the ONLY post and so I went back and reposted the clipboard and I am so very EMBARRASSED. BUT...
Just to make this post more useful than this oopsie, people in similar situations might have a look at this offering from the Chinese House of Cheap Tools:
http://www.harborfreight.com/12-in-professional-air-impact-wrench-68424.html
It's pneumatic, though, and with a coupon you can knock it down to $69. It's actually gotten some good reviews, and is capable of 700 ft./lbs. If it were electric, I'd probably buy it.
But that may come in handy to those with castle-nut issues.
Best! _________________ 'Winston,' '84 1.9 WBX Westy
Vanagon Poet Laureate: "I have suffered in
many ways, but never, never, never in silence." |
|
Back to top |
|
|
shadetreetim Samba Member
Joined: January 10, 2011 Posts: 1994 Location: Riverside, California
|
Posted: Tue Oct 15, 2013 9:12 pm Post subject: |
|
|
And here I thought this thread was about adding WiFi to Winston. _________________ Tim Potts
Doing my best every time I drive it to dispel the myth these Vanagons have to be slow!
'89 Vanagon Bluestar/Country Homes 1.8T & .77 4th
'74 Jeep CJ5 |
|
Back to top |
|
|
|