| Author |
Message |
Zander68
Samba Member
Joined: September 13, 2002
Posts: 41
|
 Posted: Thu May 01, 2003 4:06 pm Post subject: Slideing door adjustment |
 |
|
Does anyone have any info on adjustments for a sliding door on a '68?
On the latch side mine is touching the body at the top, and a 1/4"-1/2" gap at the bottom. Accordingly, the top of the door has a gap in the front which narrows as you move to the rear of the vehicle. |
|
| Back to top |
|
 |
Zander68
Samba Member
Joined: September 13, 2002
Posts: 41
|
| Posted: Thu May 01, 2003 6:48 pm Post subject: Slideing door adjustment |
|
|
No I'm not stupid,,,,Just a poor typist
"SLIDING" |
|
| Back to top |
|
|
Mark
Samba Member
Joined: January 20, 2003
Posts: 1523
Location: Victoria, BC Canada
|
| Posted: Thu May 01, 2003 9:10 pm Post subject: Slideing door adjustment |
|
|
| There are several adjustment points, and I would try adjusting the roller plate, (you should have two or three screws there) and the bottom roller assembly can be adjusted as well. From your post, I would move the top assembly towards the rear, and the bottom assembly more towards the front. Just try them a bit at a time so you don't scratch the door against the bus. This is easier if you have the Bentley manual, it's crystal clear in there w/ good pictures. Good luck. |
|
| Back to top |
|
|
|
