| Author |
Message |
wvengineer
Samba Member
Joined: August 06, 2006
Posts: 168
Location: Petersburg, West Virginia
|
 Posted: Sat Aug 09, 2008 6:48 pm Post subject: Fitting??? in the center of front axle beam |
 |
|
Hello all,
1977 2.0 FI
I've noticed (I'm not sure what to call it) a fitting in the center of the upper and lower front axle beams (not a grease fitting). Anyways I've noticed a minor leak of some kind at each one. The fitting would be located at the lower rear section. These spots are moist on both beams. Is this a problem?
Thanks,
Lance
_________________
My Resto Thread
1977 Champagne Edition I Bus (Soon to be repainted Sage Green with a Camper Special in it!) |
|
| Back to top |
|
 |
rumplestilskin
Samba Member
Joined: January 13, 2007
Posts: 963
Location: los banos,CA
|
| Posted: Sat Aug 09, 2008 7:11 pm Post subject: |
|
|
i believe what u are referring to is the little grub bolts holding the torsion bars in place. . and no don't worry about a little moisture. just worry if u get a drip
_________________
currently 71 super auto-stick, 73 ghia, 71 yellow ghia , a 68 square w71 fi, a 77 bus station wagon deluxe. and finaly finaly a 74 riveria with volvo pawer .ITS AN ADDICTION!!! |
|
| Back to top |
|
|
|
