Rusted area on my '58 Ghia

50Split · Samba Member Joined: May 19, 2000 Posts: 866 Location: 602

Does anyone know if this area (rear outer wheel well) is repoped? KGPR shows the top half of this section, but doesn't seem to go all the way down to the bottom of the fender. I need to replace this rusted out section for my '58 lowlight Ghia. It's the passenger side. If not, does any one have a dry, used section for sale? Thanks for any and all help.

Image may have been reduced in size. Click image to view fullscreen.

_________________
Quintin - IG @GFK602

anthracitedub · Posted: Fri Apr 10, 2009 6:34 pm Post subject:

You could just make it out of sheet metal...very easy.

1960bus · Posted: Sat Apr 11, 2009 6:50 am Post subject:

I think this is the lower part on the panel

http://www.karmannghia.de/bilder/H3CL.JPG

tstracy39 · Posted: Sun Apr 12, 2009 12:00 am Post subject:

The little inner piece that attaches to the crossmember and has the torsion bar hole is definately reproduced for later model Ghias, for lowlights you might be able to get one imported, or modify a later one to fit.

50Split · Samba Member Joined: May 19, 2000 Posts: 866 Location: 602

50Split · Samba Member Joined: May 19, 2000 Posts: 866 Location: 602

garabaldy · Posted: Mon Apr 13, 2009 3:45 pm Post subject:

Here is the inner rear fender that goes to the bottom of the rear of the opening. I used this on my 69.... It is for 67-74 so not sure if it will work on a 58..
http://www.karmannghia.com/products.asp?strMasterCat=1015&strYear=&strBodyType=

50Split · Samba Member Joined: May 19, 2000 Posts: 866 Location: 602

Thanks!
_________________
Quintin - IG @GFK602

pbaptist · Posted: Mon Apr 13, 2009 11:52 pm Post subject:


Hello! Log in or Register \| Help \| Donate \| Buy Shirts	See all banner ads \| Advertise on TheSamba.com

	Forum Index -> Ghia	All times are Mountain Standard Time/Pacific Daylight Savings Time
Page 1 of 1