Author |
Message |
KTPhil Samba Member
Joined: April 06, 2006 Posts: 34021 Location: Conejo Valley, CA
|
Posted: Fri Sep 22, 2017 10:59 am Post subject: Re: Pre heat tube question? |
|
|
When the longer-stroke engines (1300-up) came out the tins were extended accordingly.
As a set the lower tins for pre-heat are unique to the '67, though IIRC the left nipple was common with earlier versions. |
|
Back to top |
|
|
67rustavenger Samba Member
Joined: February 24, 2015 Posts: 9772 Location: Oregon
|
Posted: Fri Sep 22, 2017 11:14 am Post subject: Re: Pre heat tube question? |
|
|
Ghettoman wrote: |
I have a 67 bug and pre-heat tins and hardware for both sides. I heard there is a difference in the size of the tins , is this so and what is the correct dimensions for the 67 ones? Like did the 1200 have a different size than the 67 1500? The one photo I saw on Samba shows a one inch difference in the length of the tins. Which is which? thanks. |
Ghettoman, Are you asking about the tins that wrap around the heat riser tube to the intake manifold? I can get you a measurement on the width of those tins screw hole to screw hole and where the riser tube is located.
But sadly I misplaced the tins that go behind the heat riser and the cylinder tins. _________________ I have learned over the years.
Cheap parts are gonna disappoint you.
Buy Once, Cry Once!
There's never enough time to do it right the first time. But there's always enough time to do it thrice.
GFY's Xevin and VW_Jimbo! |
|
Back to top |
|
|
67rustavenger Samba Member
Joined: February 24, 2015 Posts: 9772 Location: Oregon
|
Posted: Fri Sep 22, 2017 11:34 am Post subject: Re: Pre heat tube question? |
|
|
Found them
Hope this helps. _________________ I have learned over the years.
Cheap parts are gonna disappoint you.
Buy Once, Cry Once!
There's never enough time to do it right the first time. But there's always enough time to do it thrice.
GFY's Xevin and VW_Jimbo! |
|
Back to top |
|
|
|