Author |
Message |
Vanagon Nut Samba Member
Joined: February 08, 2008 Posts: 10371 Location: Sunshine Coast B.C.
|
Posted: Fri Jan 18, 2013 12:07 am Post subject: O2 Shielding Ground? Vanagon ABA Swap. PIC, diagrams. |
|
|
Hi all.
While moving the O2 to the exhaust manifold, I noticed the O2 plug wires were taped a little tight. Peeled back some tape, discovered the black wire (shown below). I obviously dismissed it during my newb venture into harness carving. I don't recall cutting it when pulling the harness, but that was also a first time effort.
I'm not certain I'm reading Bentley correctly. I think the solid line (image below. Red arrow points to it) is the black wire. Looking at this diagram, (bottom, right of centre):
http://faculty.ccp.edu/faculty/dreed/Campingart/jettatech/techset/95aba.jpg
This seems to be the case.
I'm almost 100% sure it should, but should the black wire I've shown connect to the engine block? (ground)
It's interesting to see how the similarity between this O2 shield and the WBX.
Thanks!
Arrow points to what I think must be this black wire
_________________ 1981 Westy DIY 15º ABA
1988 West DIY 50º ABA
VE7TBN |
|
Back to top |
|
|
xoo00oox Samba Member
Joined: February 11, 2010 Posts: 2672 Location: East Nassau, NY
|
Posted: Fri Jan 18, 2013 1:28 am Post subject: |
|
|
No. I does not attach to anything. |
|
Back to top |
|
|
Vanagon Nut Samba Member
Joined: February 08, 2008 Posts: 10371 Location: Sunshine Coast B.C.
|
Posted: Fri Jan 18, 2013 10:41 am Post subject: |
|
|
Much thanks xoo00oox
Need to get through emissions testing soon. It's passed before but that wire was bugging me.
Neil. _________________ 1981 Westy DIY 15º ABA
1988 West DIY 50º ABA
VE7TBN |
|
Back to top |
|
|
Vanagon Nut Samba Member
Joined: February 08, 2008 Posts: 10371 Location: Sunshine Coast B.C.
|
Posted: Fri Jan 18, 2013 3:19 pm Post subject: |
|
|
....
found a moment to do last minute Vanagon things.
For the record, that black wire checks out to ground. Wasn't sure where in the harness it connected to 200: "Ground Connection (Shielding) in engine compartment wiring harness". At that end or elsewhere.
Neil. _________________ 1981 Westy DIY 15º ABA
1988 West DIY 50º ABA
VE7TBN |
|
Back to top |
|
|
|