Author |
Message |
Island Bumpkin Samba Member
Joined: April 22, 2013 Posts: 332 Location: Whidbey Island, Washington
|
Posted: Mon Mar 17, 2014 7:11 pm Post subject: Any Solidworks aficionados out there? |
|
|
I'm working on a project for my entry level solidworks class in college, and the project I chose I'm finding reaches out what I know of the program.
What I'm trying to do, is make a basic model of a sandrail chassis/frame. I started with what I know, basic sweeps along a path. But there has to be something that I can do that works better.
Any help is appreciated
-Jameson _________________ Vehicles:
1971 Baja Bug, 1600dp, summer/winter/summer project
Follow my progress!
http://www.thesamba.com/vw/forum/viewtopic.php?t=556996
1988 F250 SC/LB 7.3 IDI/ZF5/Dana 50 front, Sterling 10.25 rear. 4" lift -Daily-
1976 F250 Reg cab/LB Stock 300/NP435/NP205 -Long Term Project-
Axitech wrote: |
My rail is basically my "I can't take civilized life anymore this month, so I'm going camping" vehicle |
|
|
Back to top |
|
|
risk Samba Member
Joined: June 24, 2004 Posts: 710 Location: Stumpbroke, Arkansas
|
Posted: Tue Mar 18, 2014 6:17 am Post subject: |
|
|
There are some solidworks models on here that you could use as a guide:
https://grabcad.com/library?per_page=20&query=vw
For tubing, I would use the "thin feature" on your sweeps.. and assign a thickness based on the gauge. 14 gauge tubing is .083" and 12 gauge is .109" thick. Uncheck "merge result" when extruding features into other features if you want to show an edge for welding.
I built a turbo header for my bug, started modeling it in solidworks but never finished it up.
|
|
Back to top |
|
|
really-whale Samba Member
Joined: March 14, 2011 Posts: 75 Location: Melbourne, Australia
|
Posted: Tue Mar 18, 2014 1:54 pm Post subject: |
|
|
Another option is to use 'Weldment' features, although I'm not sure if this is only included in the Sheetmetal add-on to Solidworks.
Create a 3D sketch of the sandrail frame and then use weldment to assign lines in the sketch to a particular tube section. Solidworks probably has a few types of tube predefined in its library or you can create your own. Like Risk mentioned about not using "merge result", you will have the same option when using this feature. You can then use 'Trim/Extend' features to clean up unruly junctions.
If this doesn't make enough sense to get started, the Weldmente tutorial within Solidworks is quite good and might have enough detail to get you on your way. _________________ Pete - '67 Aust. RHD Squareback - Build Thread - Engine Thread |
|
Back to top |
|
|
|