Hello! Log in or Register   |  Help  |  Donate  |  Buy Shirts See all banner ads | Advertise on TheSamba.com  
TheSamba.com
 
Possible Ecotec Swap?
Forum Index -> Performance/Engines/Transmissions Share: Facebook Twitter
Reply to topic
Print View
Quick sort: Show newest posts on top | Show oldest posts on top View previous topic :: View next topic  
Author Message
CWied
Samba Member


Joined: January 19, 2015
Posts: 32
Location: Memphis, TN
CWied is offline 

PostPosted: Mon Jan 26, 2015 8:22 am    Post subject: Possible Ecotec Swap? Reply with quote

I'm doing a lot of reading on these and they seem to be a good upgrade. AFI makes a swap kit (motor, transmission plate, flywheel, harness and ecu) I'm just looking for someone who has done it and what else would be needed to finish it

What all would be needed after the AFI stage 2 kit (http://www.alphafabindustries.com/collections/ecotec-solutions/products/afi-2-4l-le5-ecotec-swap-combo-stage-ii) to make it truly turn-key?

- Fuel system (tank, pump, lines, filter, etc)
- Motor mounts?
- Cooling system (radiator, hoses, etc)
- Clutch?
Back to top
View user's profile Send private message Classifieds Feedback
CWied
Samba Member


Joined: January 19, 2015
Posts: 32
Location: Memphis, TN
CWied is offline 

PostPosted: Mon Jan 26, 2015 8:26 am    Post subject: Reply with quote

Looks like the adapter plate for the transmission that allows it to be bolted to VW transmissions. Going off that, I'm sure the VW clutch would be used with their included flywheel.
Back to top
View user's profile Send private message Classifieds Feedback
CWied
Samba Member


Joined: January 19, 2015
Posts: 32
Location: Memphis, TN
CWied is offline 

PostPosted: Mon Jan 26, 2015 5:20 pm    Post subject: Reply with quote

Gonna get Alpha Fab on the phone tomorrow.
Back to top
View user's profile Send private message Classifieds Feedback
jsturtlebuggy
Samba Member


Joined: August 24, 2005
Posts: 4496
Location: Fair Oaks/Orangevale, CA
jsturtlebuggy is offline 

PostPosted: Mon Jan 26, 2015 10:34 pm    Post subject: Reply with quote

You may get more replies if you post about what you are wanting to do in the Samba off road section or fiberglass section. There are more engine swaps with Bajas and Buggies.
I know of several fiberglass buggies that are using the Ecotec motors very successfully.
_________________
Joseph
Fair Oaks/Orangevale, CA
Elrod Motorsports
Motion Tire Motorsports
Having fun with Dune Buggies since 1970
Into Volkswagens since 1960
Back to top
View user's profile Send private message Gallery Classifieds Feedback
CWied
Samba Member


Joined: January 19, 2015
Posts: 32
Location: Memphis, TN
CWied is offline 

PostPosted: Tue Jan 27, 2015 3:05 pm    Post subject: Reply with quote

jsturtlebuggy wrote:
You may get more replies if you post about what you are wanting to do in the Samba off road section or fiberglass section. There are more engine swaps with Bajas and Buggies.
I know of several fiberglass buggies that are using the Ecotec motors very successfully.


Thanks for the tip. My bad for using the wrong forum! Embarassed
Back to top
View user's profile Send private message Classifieds Feedback
Display posts from previous:   
Reply to topic    Forum Index -> Performance/Engines/Transmissions All times are Mountain Standard Time/Pacific Daylight Savings Time
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum

About | Help! | Advertise | Donate | Premium Membership | Privacy/Terms of Use | Contact Us | Site Map
Copyright © 1996-2023, Everett Barnes. All Rights Reserved.
Not affiliated with or sponsored by Volkswagen of America | Forum powered by phpBB
Links to eBay or other vendor sites may be affiliate links where the site receives compensation.