Source for new 7 prong plug for engine wire harness?

[xoo00oox]

Does anyone know where these plugs for the 85-91 Vanagon can be purchased from?

It needs to be able to plug into this....

Andrew-

[westylife]

Im not sure but I do know that Bostig uses them on their "new" wire harness'. If nobody else chimes in, you might ask if they will sell you one?

WL
_________________
1983.5 Westfalia Bostig RG1

[PDXWesty]

that looks similar to a trailer connector. Scroll through this list and you'll see some that might work.

http://www.amazon.com/s/ref=nb_sb_noss_1?url=searc...in+c%2Caps
_________________
89 Westy 2.1 Auto

[GreenMachineVW]

Probably NLA, as the big suppliers don't have them. This might get you started:
http://octopart.com/925265-0-te+connectivity+%2F+amp-21418921

Part can be seen on this page:
http://www.vw-bus-land.de/tips/stecker/stecker.html

PM me if you want to buy just one or two: I have some used ones.

[VWhead]

Tyco Amp - 925264 is what your looking for. That is the female plug,
As you know its NLA from VW, I was able to get a few new ones straight from www.te.com. Just ask for a sample, I don't know far my luck will run

My 1.8T harness's I build need them too. But my used supply is getting low. Hope that helps!

Paul
_________________
81' Single Cab Syncro 1.8T GMW
88' 2wd Westy 1.8T GMW
www.gmwerks.com
---------------------------------------------

[xoo00oox]

Thanks for all the tips guys.

I feel bad every time I chop one off what once was a good used uncut harness.

Perhaps this is something a guy with a 3d printer could scan and print?

[danfromsyr]

if you used a pin remover and pulled the pins/wires out of the plug
would they (the oe pins) fit into a molex 8 pole plug? would require work for each side but might solve a supply issue.
_________________