How best to preserve lettering on fan shroud? |
Clean like the bodywork and leave |
|
100% |
[ 6 ] |
Clean, Polish and apply wax |
|
0% |
[ 0 ] |
Clean, NO polish and then wax |
|
0% |
[ 0 ] |
Clean and then apply liquid wrap aerosol |
|
0% |
[ 0 ] |
Other ideas, please tell! |
|
0% |
[ 0 ] |
|
Total Votes : 6 |
|
Author |
Message |
mcdonaldneal Samba Member
Joined: June 13, 2013 Posts: 2649 Location: Gullane, Scotland
|
Posted: Wed Feb 04, 2015 3:12 pm Post subject: Preserving fan shroud stencilled lettering |
|
|
I'm looking for advice.
I'm cleaning up the engine and engine bay of our largely original '69 Ghia. The tin is in good order, and the fan shroud still has the stencilled lettering and a very faded timing decal on it.
I am keen to preserve the look of this as much as possible, and I am not certain how to proceed. The lettering might rub off quite easily, as I know many folk have it faded or absent. Clearly gentle cleaning in the first place, but is there a protective layer that could be put over the top, bearing in mind it will be exposed to moderate heat in the engine compartment (not sure how hot the fan shroud gets!?) and potentially contamination with oil and gasoline.
I'm thinking possibly just body wax over the top, but I also have a clear plastic flexible, spray on wrap which is applied in several layers and is designed to protect bodywork, like a vinyl wrap.
http://www.frost.co.uk/review-frost-liquid-wrap-rubber-coating-spray
Thoughts, comments and opinions all welcome. (Note: may be ignored! ) _________________ 1978 marino yellow Bay Dormobile camper
1969 signal orange Karmann Ghia convertible
1976 martini olive Bay Dormobile camper
Stop dead photo links! Post photos to The Samba Gallery! |
|
Back to top |
|
|
SoCalJes Samba Member
Joined: November 02, 2011 Posts: 1093 Location: Broward, FL
|
Posted: Wed Feb 04, 2015 4:19 pm Post subject: |
|
|
Clean and lay a coat of high temp matte clear _________________ Jesse
71 Ghia
______________________________________
Just because it didn't come that way, doesn't mean it shouldn't have. |
|
Back to top |
|
|
-Zodiac- Samba Member
Joined: September 22, 2014 Posts: 782 Location: Pensacola/milton, florida
|
Posted: Wed Feb 04, 2015 11:30 pm Post subject: |
|
|
Maybe boiled linseed oil? I haven't used it on anything, si I don't know how it will handle the stamps, or any temps. But some people use it for preserving and bringing back faded paint. Maybe someone else can shed some light . _________________ 1973 karmann ghia - current, not the last VW.
1947 Chevy stylemaster - gone, but not forgotten.
1995 Ford F-150 - gone, hatred for it lives. |
|
Back to top |
|
|
akear Samba Member
Joined: August 18, 2013 Posts: 359 Location: Los Angeles
|
Posted: Thu Feb 05, 2015 12:08 pm Post subject: |
|
|
Those letters look great for being 46 years old. I'd leave them alone. |
|
Back to top |
|
|
tisius Samba Member
Joined: July 11, 2011 Posts: 1570 Location: Rotterdam,NL (+Chicago,IL)
|
Posted: Fri Feb 06, 2015 3:18 am Post subject: |
|
|
You could opt for a clear coat to seal the surface, but make sure that the clear coat paint can deal with the heat of the engine.
And once you spray the paint on you can't go back _________________ drive it like you just robbed the bank
you don't have to be crazy to be into VW's, but it sure helps!!
.... if it ain't dutch, it ain't much! |
|
Back to top |
|
|
aero3113 Samba Member
Joined: March 03, 2013 Posts: 196 Location: Setauket, NY (Long Island)
|
Posted: Fri Feb 06, 2015 5:42 am Post subject: |
|
|
akear wrote: |
Those letters look great for being 46 years old. I'd leave them alone. |
I agree, leave it. You don't know what kind of paint was used for the lettering. Whatever you spray/brush on can dissolve the paint in seconds. 46 years and it still looks that good, no reason to take a chance.
The decal is toast,take it off and find a new one to put on. |
|
Back to top |
|
|
bhartwell59 Samba Member
Joined: December 28, 2014 Posts: 791 Location: dallas, tx
|
Posted: Fri Feb 06, 2015 7:38 am Post subject: |
|
|
aero3113 wrote: |
akear wrote: |
Those letters look great for being 46 years old. I'd leave them alone. |
I agree, leave it. You don't know what kind of paint was used for the lettering. Whatever you spray/brush on can dissolve the paint in seconds. 46 years and it still looks that good, no reason to take a chance.
The decal is toast,take it off and find a new one to put on. |
agreed...it's just a white, rotted blob at this point. love the stenciled lettering on the tin. |
|
Back to top |
|
|
|