Markii Samba Member
Joined: December 29, 2015 Posts: 4 Location: Australia
|
Posted: Mon Dec 12, 2016 9:48 pm Post subject: Bore and sleeve Judson Supercharger |
|
|
I am looking for info on re-sleeving a damaged Judson rotor bore. It also is cracked between two of the ports so I was thinking it could be welded, sleeved and bored back to std. I think I saw an article on this some time back where they used a paper template for the ports and cut them into the sleeve, but can't find the article or info. Thanks
|
|