Author |
Message |
caseyl Samba Member
Joined: September 28, 2016 Posts: 57 Location: VT
|
Posted: Wed Sep 27, 2017 4:07 pm Post subject: Lobro CV Joints on EMPI Shafts - Is it possible? |
|
|
Can I put Lobro CV joints on the shaft that comes with the new EMPI axleshafts?
If I can't where can I buy used or aftermarket Lobro compatible axleshafts.
Thanks! |
|
Back to top |
|
|
snwbrdr435 Samba Member
Joined: August 10, 2013 Posts: 337 Location: North Of Boston
|
Posted: Wed Sep 27, 2017 5:20 pm Post subject: Re: Lobro CV Joints on EMPI Shafts - Is it possible? |
|
|
What trans are you tossing these on auto or man? I have a few auto axle shafts in my parts bin and am also in MA.. |
|
Back to top |
|
|
candyman Samba Trout Slayer
Joined: December 20, 2003 Posts: 2694 Location: Missoula MT
|
Posted: Wed Sep 27, 2017 7:37 pm Post subject: Re: Lobro CV Joints on EMPI Shafts - Is it possible? |
|
|
caseyl wrote: |
Can I put Lobro CV joints on the shaft that comes with the new EMPI axleshafts?
If I can't where can I buy used or aftermarket Lobro compatible axleshafts.
Thanks! |
Yes, we installed a set of 944 joints on a buddies rig that had empi axles. This was a manual. His new empi joints lasted about 2000 miles. We were on a road trip when they failed, van cafe overnighted him some new 944 joints. I was concerned about the fit but it was fine and still going strong for him. I would have to presume that lobro would also work if the 944s did |
|
Back to top |
|
|
dobryan Samba Member
Joined: March 24, 2006 Posts: 16508 Location: Brookeville, MD
|
|
Back to top |
|
|
Christopher Schimke Samba Member
Joined: August 03, 2005 Posts: 5392 Location: PNW
|
Posted: Wed Sep 27, 2017 9:10 pm Post subject: Re: Lobro CV Joints on EMPI Shafts - Is it possible? |
|
|
Some axles have a spline diameter that is just a skosh bigger than stock and the Lobro CVs can be a tight fit. The spline count is the same and the Lobro CVs will fit, but it's tight. _________________ "Sometimes you have to build a box to think outside of." - Bruce (not Springsteen)
*Custom wheel hardware for Audi/VW, Porsche and Mercedes wheels - Urethane Suspension Bushings*
T3Technique.com or contact me at [email protected] |
|
Back to top |
|
|
caseyl Samba Member
Joined: September 28, 2016 Posts: 57 Location: VT
|
Posted: Wed Sep 27, 2017 9:38 pm Post subject: Re: Lobro CV Joints on EMPI Shafts - Is it possible? |
|
|
Thanks guys! I will rebuild these shafts with Lobro CV's.
snwbrdr435 wrote: |
What trans are you tossing these on auto or man? I have a few auto axle shafts in my parts bin and am also in MA.. |
I am actually in Orange County CA right now for work. I will send you a PM we should meet up when I get back to MA... If I go back! |
|
Back to top |
|
|
|