Author |
Message |
Rockbound Samba Member
Joined: September 06, 2017 Posts: 303 Location: Pennsylvania
|
Posted: Fri Sep 29, 2017 11:01 am Post subject: what drill bit for dimpling front torsion leaves?? |
|
|
ok been threw tons of good threads on narrowing and adding adjusters to the front i beams, but i can't seem to find what everyone is using to re dimple the leaves after cutting them down?
can some one supply a link to or any info on what type/size bit they are using please?
found this thread, but looking for more specific answer
also found to drill 1/8 pilot and then use 90 degree counter sink bit.. is this the best method or is something better now a days? that was an old thread..
https://www.thesamba.com/vw/forum/viewtopic.php?t=551728&highlight=bit+torsion+dimple |
|
Back to top |
|
|
TDCTDI Samba Advocatus Diaboli
Joined: August 31, 2013 Posts: 12861 Location: North Carolina
|
Posted: Fri Sep 29, 2017 11:37 am Post subject: Re: what drill bit for dimpling front torsion leaves?? |
|
|
This is what I used, then tapered the grub screws to match.
And here's how I went about it.
https://www.thesamba.com/vw/forum/viewtopic.php?t=...p;start=60 _________________ Everybody born before 1975 has a story, good, bad, or indifferent, about a VW.
GOFUNDYOURSELF, quit asking everyone to do it for you!
An air cooled VW will make you a hoarder.
Do something, anything, to your project every day, and you will eventually complete it. |
|
Back to top |
|
|
Rockbound Samba Member
Joined: September 06, 2017 Posts: 303 Location: Pennsylvania
|
Posted: Wed Oct 04, 2017 6:56 am Post subject: Re: what drill bit for dimpling front torsion leaves?? |
|
|
thanks! |
|
Back to top |
|
|
VW_Jimbo Samba Member
Joined: May 22, 2016 Posts: 9969 Location: Huntington Beach, CA
|
Posted: Thu Oct 26, 2017 7:32 am Post subject: Re: what drill bit for dimpling front torsion leaves?? |
|
|
Thank you for posting up your experience and knowledge TDCTDI! Very much appreciated! _________________ Jimbo
There is never enough time to do it right the first time, but all the time necessary the second time!
TDCTDI wrote: |
Basically, a whole bunch of fuckery to achieve a look. |
67rustavenger wrote: |
GFY's Xevin and VW_Jimbo! |
|
|
Back to top |
|
|
mark tucker Samba Member
Joined: April 08, 2009 Posts: 23937 Location: SHALIMAR ,FLORIDA
|
Posted: Thu Oct 26, 2017 7:55 am Post subject: Re: what drill bit for dimpling front torsion leaves?? |
|
|
eye wood thunk, a 1/8 cobalt pilot bit to put a small divot where you want it and then a 5/16 ball endmill.possiably a 3/8 ballend mill it's been a while since I looked at the springs. |
|
Back to top |
|
|
|