Author |
Message |
Bug53 Samba Member
Joined: February 22, 2021 Posts: 704 Location: Pawcatuck, CT.
|
Posted: Fri Feb 17, 2023 2:20 pm Post subject: Cam Thrust surface |
|
|
I have a new Web 86A.
I started out polishing up the thrust surface and see the cast iron actually has noticeable grain.
How far should I go or should I worry about it at all?
Last edited by Bug53 on Sat Feb 18, 2023 9:19 pm; edited 1 time in total |
|
Back to top |
|
|
Alstrup Samba Member
Joined: July 12, 2007 Posts: 7215 Location: Videbaek Denmark
|
|
Back to top |
|
|
RWK Samba Member
Joined: June 24, 2009 Posts: 1349 Location: S.W. MI
|
Posted: Sat Feb 18, 2023 7:10 am Post subject: Re: Can Thrust surface |
|
|
Yes, don't exceed the clearance spec.
I like to center punch the edge of the bolt ends to distort the threads, keeps them from coming out, rather then locktite. _________________ 73 Type 181
63 Type 113
63 Type 261- 428 071
62 Type 241-378 025 178 530 |
|
Back to top |
|
|
modok Samba Member
Joined: October 30, 2009 Posts: 26787 Location: Colorado Springs
|
Posted: Sat Feb 18, 2023 12:10 pm Post subject: Re: Cam Thrust surface |
|
|
I don't really know but probably it's good.
Just a little helps a a lot more than doing nothing at all.
Or, check the thrust play then decide.
And edit the title please, |
|
Back to top |
|
|
mark tucker Samba Member
Joined: April 08, 2009 Posts: 23937 Location: SHALIMAR ,FLORIDA
|
Posted: Sat Feb 18, 2023 3:54 pm Post subject: Re: Can Thrust surface |
|
|
the web camsIve used were dfl coated and look like that, if you sand off the dfl you screwed up. dont sand any more. |
|
Back to top |
|
|
Bug53 Samba Member
Joined: February 22, 2021 Posts: 704 Location: Pawcatuck, CT.
|
Posted: Sat Feb 18, 2023 9:26 pm Post subject: Re: Can Thrust surface |
|
|
mark tucker wrote: |
the web camsIve used were dfl coated and look like that, if you sand off the dfl you screwed up. dont sand any more. |
It’s only been smoothed with a 3M Scotchbrite pad.
I think I’ll do my end play.
Right now it’s less than zero so thrust bearings have to be adjusted with some 600. |
|
Back to top |
|
|
|