Author |
Message |
hulken Samba Member
Joined: January 29, 2009 Posts: 95 Location: Norway
|
Posted: Wed May 09, 2018 7:24 am Post subject: Quarter popouts |
|
|
Has anyone seen these fitted to a 2-door salon? I have found pictures, but never seen one. If anyone has a set a would pay a good price for it!
I might have located the windows with frames, but have no idea og how the rubber gaskets look like. Does anyone know?
|
|
Back to top |
|
|
raygreenwood Samba Member
Joined: November 24, 2008 Posts: 21513 Location: Oklahoma City
|
Posted: Wed May 09, 2018 9:43 am Post subject: Re: Quarter popouts |
|
|
hulken wrote: |
Has anyone seen these fitted to a 2-door salon? I have found pictures, but never seen one. If anyone has a set a would pay a good price for it!
I might have located the windows with frames, but have no idea og how the rubber gaskets look like. Does anyone know?
|
At one point in time...when I lived in REALLY hot climate...I explored putting those in.
I was to the point of pricing drilling a hole in my glass without destroying it...hopefully....and trying to have frames fabricated. The mounts for the latch are built into the C-pillar under the headliner.
I did not have any welding skills at the time and kind of gave up on trying to figure out the frame and hinge design. I figured I could just use type 3 latches.
Those would be interesting. I have no idea exactly what the gasket profile would look like. Similar to type 3 would be a guess.
From the parts list...the latches and fasteners are type 3
Also from the parts list it was only available on the two door 411 and 412.
Interesting! Would love to see some pictures of the parts. Ray |
|
Back to top |
|
|
hulken Samba Member
Joined: January 29, 2009 Posts: 95 Location: Norway
|
Posted: Wed May 09, 2018 11:39 am Post subject: Re: Quarter popouts |
|
|
I have ordered 2 NOS windows with frames, and been tipped about using type 3 rubber seals. Will also need hinges from type 3 fastback and some other small parts.
Pictures from the parts dealer...
|
|
Back to top |
|
|
KTPhil Samba Member
Joined: April 06, 2006 Posts: 34003 Location: Conejo Valley, CA
|
Posted: Wed May 09, 2018 12:53 pm Post subject: Re: Quarter popouts |
|
|
Interesting about Type 3 fastback "hinges"... there is a long latch at the rear, but no actual "hinge" since the frameless glass bends to open. You probably mean what the parts list calls a "fastener" and it has a 311 part number. |
|
Back to top |
|
|
hulken Samba Member
Joined: January 29, 2009 Posts: 95 Location: Norway
|
Posted: Wed May 09, 2018 2:21 pm Post subject: Re: Quarter popouts |
|
|
The rear "hinge" or fastener. Same as type 3 fastback. |
|
Back to top |
|
|
|