Author |
Message |
Pau Samba Member
Joined: April 09, 2002 Posts: 341 Location: Euskal Herria
|
Posted: Wed May 16, 2018 9:04 am Post subject: bay seat and door panels |
|
|
Hello again.
I am back and I have a little question.
Do baywindow door panels fit in a non hacked 67 deluxe (sliding door) ?
Just pre-72 bay? all of them? None of them?
Thank you very much.
Cheers,
Pau _________________ Freedom for the Catalan Countries
Si ens destrossen les contrades alçarem les barricades !!*!! |
|
Back to top |
|
|
Clara Samba Member
Joined: June 14, 2003 Posts: 12400
|
Posted: Wed May 16, 2018 6:52 pm Post subject: Re: bay seat and door panels |
|
|
Pau wrote: |
Hello again.
I am back and I have a little question.
Do baywindow door panels fit in a non hacked 67 deluxe (sliding door) ?
Just pre-72 bay? all of them? None of them?
Thank you very much.
Cheers,
Pau |
No, none of the bay interior panels fit straight over into a 67 bus.
(except the rear hatch panel from an early bay)
I do offer interior panels for a sliding door splitty. pm me if interested. |
|
Back to top |
|
|
Pau Samba Member
Joined: April 09, 2002 Posts: 341 Location: Euskal Herria
|
Posted: Thu Aug 16, 2018 4:55 am Post subject: Re: bay seat and door panels |
|
|
Thank you Clara for your answer.
I only find bay stuff, so my question is:
- would '76 bay benches (middle and rear) fit the '67 deluxe? I found answers on early bay middle seats, but nothing about rear ones or late 70's.
Thank you very much. _________________ Freedom for the Catalan Countries
Si ens destrossen les contrades alçarem les barricades !!*!! |
|
Back to top |
|
|
Clara Samba Member
Joined: June 14, 2003 Posts: 12400
|
Posted: Thu Aug 16, 2018 7:06 am Post subject: Re: bay seat and door panels |
|
|
Pau wrote: |
Thank you Clara for your answer.
I only find bay stuff, so my question is:
- would '76 bay benches (middle and rear) fit the '67 deluxe? I found answers on early bay middle seats, but nothing about rear ones or late 70's.
Thank you very much. |
For the rear seat, I have seen this question answered.
back seat is an inch or two narrower.
Fits in a split kombi, that has no heater log
Basically, the bottom part middle leg will hit the heater log. possibly a 68 bottom part works. Or re-weld the leg?
Late bay backrest can set there, but will not be able to be bolted in.
early bay backrest can be bolted in with long brackets.
HTH |
|
Back to top |
|
|
|