71 ignition switch electrical question

[Dead 1]

Pardon me if I missed the answer out there in samba land. Im trying to remove the little round switch from the lock cylinder. Is it as simple as yanking it out? I removed a small little screw in the ignition cylinder and tried to pull out the old switch with no luck. Any ideas?
_________________
"I reject your reality and replace it with my own"

"The American Dream - true enough because you gotta be asleep to believe it"
________________________________________
71, 1776 cc.

[aeromech]

There are four 6mm phillips head screws holding the steering column, remove those. The column will shift aft and now you can look up and see the lock assembly. There's a small, straight slot set screw to remove with a jewelers screwdriver. At this point the electrical side of the switch can be pulled towards the drivers side. It's tough, but can be done.
_________________
Lead Mechanic: San Diego Air and Space Museum
Licensed Airframe and Powerplant Mechanic
Licensed Pilot (Single engine Land)
Boeing 727,737-200-300-400,757,767
Airbus A319,320,321
DC9/MD80
BAe146
Fokker F28/F100
VW type 1 1962,63,65,69,72
VW Type 2 1971 (3 ea.) 1978, 1969
VW Jetta
VW Passat
Capable of leaping tall buildings in a single bound

[Dead 1]

Thank you. I’ll giver another try
_________________
"I reject your reality and replace it with my own"

"The American Dream - true enough because you gotta be asleep to believe it"
________________________________________
71, 1776 cc.

[SGKent]

https://www.thesamba.com/vw/forum/viewtopic.php?t=709166&highlight=set+screw
_________________
“Most people don’t know what they’re doing, and a lot of them are really good at it.” - George Carlin

[Dead 1]