Will Kennedy Ring Fit A Sachs HD?

[bugguy1967]

The center spacer on my Sachs HD 200mm clutch is starting to break apart prematurely. Everything else looks fine - t/o brg, press plate, disk. I just realized that I have a new Kennedy center spacer that I pulled off for mating with a late model trans. Will that one fit in the Sachs plate? I'm not out there right now to check.

FYI, it's the late style plate, not the F&S three finger.
_________________
"A petrol engine can start readily, run smoothly and give every appearance of being in good order, without necessarily being in good tune." - Colin Campbell, "The Sportscar Engine"

[modok]

"probably"
watch out for this
https://www.thesamba.com/vw/forum/viewtopic.php?p=9033390&highlight=#9033390

[bugguy1967]

Thanks Glen. My clutch fingers were oddly tilted to one side when I pulled the clutch off. I torqued them correctly. Not sure what happened. Anyways, I had a spare clutch. Put the Kennedy ring in and now it shifts better than before.
_________________
"A petrol engine can start readily, run smoothly and give every appearance of being in good order, without necessarily being in good tune." - Colin Campbell, "The Sportscar Engine"