Author |
Message |
W1K1 Samba Member
Joined: March 04, 2004 Posts: 4921 Location: Southern AB
|
Posted: Thu Sep 17, 2020 1:24 pm Post subject: dellorto set up |
|
|
I have used this method for carb set up in the past, and with a vacuum gauge it's simple, but my current dells don't have a vacuum advance nipple on either. I wanted to check the setting of the throttle plates. Is there a simple alternative method out there?
From Aircooled.net
Quote: |
Now you have to set the throttle plates to a good position so as not to uncover the progression holes. If you have a vacuum plug for the SVDA port on the carburetor, remove it and connect a hose and listen. Or connect a vacuum gauge.
Tighten the idle speed adjusting screw (idle speed increases) until you read a reading on the vacuum gauge (or until you hear a suction sound at the end of the hose). Now loosen until the vacuum disappears.
Synchronize the second carburetor. |
_________________ http://www.thesamba.com/vw/archives/manuals/jim_martin_engine_build.php
1973 super
1965 squareback 1500E
1971 bay window westy- subi swap |
|
Back to top |
|
|
j-dub Samba Member
Joined: November 09, 2003 Posts: 865 Location: Phoenix, AZ
|
Posted: Thu Sep 17, 2020 5:21 pm Post subject: Re: dellorto set up |
|
|
Are they installed already? If not, set the butterflies so that the bottom of the lowest progression hole is just barely exposed. Check that they are all showing, ie. you don't have a bent throttle shaft.
Borrowed this image from the gallery so you can get an idea, look at the hole on the left.
Another one, i think this one is a bit too far open
_________________ 1957 Oval rag
"POLICE STATION TOILET STOLEN ... Cops have nothing to go on." |
|
Back to top |
|
|
W1K1 Samba Member
Joined: March 04, 2004 Posts: 4921 Location: Southern AB
|
Posted: Fri Sep 18, 2020 7:22 am Post subject: Re: dellorto set up |
|
|
They are on, and running, I just wanted to check everything over on my settings
I suppose I could pull the plug covering the progression holes and check that way. _________________ http://www.thesamba.com/vw/archives/manuals/jim_martin_engine_build.php
1973 super
1965 squareback 1500E
1971 bay window westy- subi swap |
|
Back to top |
|
|
74 Thing Samba Member
Joined: September 02, 2004 Posts: 7394
|
Posted: Fri Sep 18, 2020 8:41 am Post subject: Re: dellorto set up |
|
|
W1K1 wrote: |
They are on, and running, I just wanted to check everything over on my settings
I suppose I could pull the plug covering the progression holes and check that way. |
That is the best way-may need a lighted mirror to make viewing easier. I bought a Husky brand tool like this at Home Depot that has come in handy. |
|
Back to top |
|
|
|