Dougster43 Samba Member
Joined: May 11, 2018 Posts: 182 Location: Texas
|
Posted: Mon Apr 19, 2021 8:16 pm Post subject: Body cart and door stand up for grabs |
|
|
My project has reached the point where I don't need the body cart I built and will only need the door stand for a few more weeks. I will gladly donate them to the next Thing nut that is taking on a restoration, you just need to figure out how to get them from the north Dallas area. If no takers I will cut them up but it would be a shame to let them go to waste.
Credit to the Domeck bros on the body cart design - don't know them but I used their sketch to make my cart. I did build the cart higher and made it 2 pieces so it splits in half and also allows for some adjustment to the length.
|
|
oscarsnapkin Samba Member
Joined: October 22, 2013 Posts: 557 Location: Bucks County, PA
|
Posted: Tue Apr 20, 2021 1:36 pm Post subject: Re: Body cart and door stand up for grabs |
|
|
I was just admiring your cart in one of your posts about a day or two ago. Wish I was closer so I could grab it. I just separated my body/chassis about a week ago, ended up using a sawhorse on the front and two tall jack stands on the rear. It’s nice and sturdy but your cart’s mobility would be handy.
_________________ - 1977 CEI Sunroof Bus 2.0L F.I. Hydraulic Lifters
- 1973 Thing
"It’s so easy to laugh, it’s so easy to hate, it takes strength to be gentle and kind." |
|