Ghia lift points

[Olli from NJ]

Can someone post pictures of a Ghia or Bug on a two post lift? I have a two post lift and would like to lift my Ghia. I figure the torsion bar housing in the rear but where in the front? The pan, towards the outboard side, roughly in front of where the door hinge post is? Pictures would help. I have been jacking and putting Ghias and Bugs on jackstands for 40 years but never raised one with a two post lift. Thanks.

[evanfrucht]

Yes I can. Give an hour or so. I have my Bug up in the air currently.

The simple answer is basically along the rails under the heater channel.
_________________
1967 Bug ( the daily rod )
1964 Fury Wagon ( the pavement shredder )

[txoval]

agree...for the front also can use the frame head at outside points

[Teeroy]

On my lift I put the short arms under the caps for the torsion bars, long ends, I put the pads under the ends of the napolian hat bolts (nice flat spot on pan that wont fold over). Have a ghia on it now but wont be home for a couple hours to take picture
_________________
Pres. Rivercity VW Club www.rcvwclub.org
Founder Derr Wheat Panzers (DWP)
ARR #3
www.autosportsnorthwest.org

[Olli from NJ]

That would be awesome if you guys can post pictures later. Thank you!

[Teeroy]

Here you go

_________________
Pres. Rivercity VW Club www.rcvwclub.org
Founder Derr Wheat Panzers (DWP)
ARR #3
www.autosportsnorthwest.org

[Olli from NJ]

Outstanding pictures! Thank you very much!

Olli