| Author |
Message |
Karmann Gheezer
Samba Member
Joined: April 12, 2006
Posts: 429
|
 Posted: Wed Jan 25, 2023 9:19 pm Post subject: Need Measurement of Bumper Support Hole in Rear Fender |
 |
|
I am finishing a long time restoration on a ’60 Beetle cabriolet. It didn’t come with fenders but found a really nice set of 4 that came off a ’58 at a swap meet. When I installed the rear bumper I realized there is no bumper support hole. I need to know these three the measurements of the support hole to finish the rear bumper. Can anyone help please? Any help highly appreciated.
Distance from edge of bumper to edge of support hole.
Diameter of hole.
Distance from top edge of bumper bracket hole to edge of support hole.
_________________
 |
|
| Back to top |
|
 |
mukluk
Samba Member
Joined: October 18, 2012
Posts: 7023
Location: Clyde, TX
|
|
| Back to top |
|
|
Karmann Gheezer
Samba Member
Joined: April 12, 2006
Posts: 429
|
| Posted: Thu Jan 26, 2023 10:34 am Post subject: Re: Need Measurement of Bumper Support Hole in Rear Fender |
|
|
*
This is perfect. Helps greatly. Thank you so much.
_________________
|
|
| Back to top |
|
|
|
