| Aaron |
Thu Nov 21, 2002 11:01 pm |
|
| anyone have a good trick for getting a stubborn inner bearing race out of a drum? [The outer one was no problem] |
|
| [email protected] |
Fri Nov 22, 2002 12:13 pm |
|
| Did you try heating up the drum a little with a torch and knocking it out with a punch from the other side? |
|
| Aaron |
Fri Nov 22, 2002 6:59 pm |
|
| I did try heating up the drum; the problem is that there is almost no lip to place the punch on. I'm going to try grinding the drum away a little with a dremel so i have a better surface to hit. |
|
| TimGud |
Fri Nov 22, 2002 8:16 pm |
|
| Try dressing up your drift punch on the grinder and then try to drive out the race. Good luck. |
|
| [email protected] |
Fri Nov 22, 2002 11:49 pm |
|
if you clean all the grease out you may find 2 indents in the casting that you can get a long punch on, be sure to work both sides equally to prevent binding.
It is possible to grind a notch in the race and then hit it with a chisel to crack it, then it falls out. |
|
| Aaron |
Sun Nov 24, 2002 9:52 am |
|
| thanks for the ideas, I finally got it out by grinding away the drum a little with a dremel. This gave me a nice solid edge to put a punch on. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|