| travis1488 |
Mon Apr 07, 2008 10:49 pm |
|
| Does anyone have a up close picture of each individual carb on a pair of idfs with the hex bar linkage hooked up? I bought a new set of redline 44 idfs and I have tried every throttle lever that came on the carb and the extra ones in the kit And I cant get them right. I hope someone understands what I'm talking about thanks |
|
| Matt Wilson |
Tue Apr 15, 2008 1:06 pm |
|
| On the throttle shaft you should have a teardrop shaped stamped metal plate. The fat end of the teardrop goes on the shaft, and the small end has a hole in it. Through that hole will go a hex shaft with male threads on one end and female threads in the other. This shaft interfaces the heim joints with the tear drop. One side will have a longer shaft due to the staggered cylinder arrangement. |
|
| Dale M. |
Tue Apr 15, 2008 4:07 pm |
|
Here is arms you need...
http://www.mamotorworks.com/acvw-1-17-3399.html
Upper arm in picture is for drivers side carb...
Lower arm in picture is for passenger side carb..(its actually backwards in picture and is installed "turned over" as to way pictured)..
Dale |
|
Powered by phpBB © 2001, 2005 phpBB Group
|