| Eric H |
Thu May 01, 2008 9:47 am |
|
| I noticed on my flywheel that there is a small groove carved into it where the rear main seal was riding on it. Does this mean the flywheel is shot or can I salvage it? |
|
| akokarski |
Thu May 01, 2008 10:47 am |
|
| Post a pic |
|
| Eric H |
Thu May 01, 2008 11:13 am |
|
| LOL I tried but my crappy camera wont focus in on it without it getting fuzzy.....Regardless I just made an executive decision and drove out to DRD and bought a new one. Its for a complete rebuild and with my luck I would get it all together and the dang thing would leak from the seal. I would rather have the wife yell at me for the extra $120 then face the real aggrivation of pulling the engine and redoing it. I can tone her out easier then an oil leak...... :D |
|
Powered by phpBB © 2001, 2005 phpBB Group
|