TheSamba.com :: View topic - Setting EDIS 36-1 wheel

Fri Oct 28, 2011 9:14 pm

Ok I'm looking at mounting my 36-1 wheel and just want to make sure I have the right idea when I do it. From what I've read with the pulley at TDC and if I mount the VRS right at the case line it should look like the first picture on the left and or as the picture on the right shows still with the pulley at TDC but I move the VRS 30deg the 36-1 wheel will move 30deg as well. As long as the VRS and the missing tooth are at 90deg, is that right.

Fri Oct 28, 2011 10:28 pm

yep, that's right

Fri Oct 28, 2011 10:48 pm

Good.

Thanks

Sat Oct 29, 2011 8:31 am

Good "live" graphic here....

http://www.autosportlabs.net/Ford_EDIS_technical_information

Dale

Sun Oct 30, 2011 5:55 am

From my understanding, you don't HAVE to have the -1 90 degrees from the sensor, you set it up in the megasquirt software. If you don't have it at 90 degrees, you lose the EDIS limp home function. Can anyone verify this?

Sun Oct 30, 2011 11:32 am

If you uses the EDIS module, you must have the 90* trigger angle or the module will fire at the wrong advance and limp home mode will be off by the same amount. If you are running sans EDIS module and MS is direct firing, you can put in whatever trigger angle you want.