| jclayc |
Sat Jul 06, 2024 6:25 pm |
|
What’s a normal amount of side to side play on a clutch release bearing shaft? See the video below. I have a rancho 12v swingaxle trans for my 63 ragtop. Looks like all bearings are new and clips are in place as you’d expect… but the bearing is off center by default with enough horizontal play that i can push the shaft to the side so it’s centered… when i let go, it un-centers itself.
|
|
| kreemoweet |
Sat Jul 06, 2024 6:47 pm |
|
| "Centered" on what? The input shaft? Why are you assuming the input shaft is in it's normal (installed) position, when there is no needle bearing holding it in place? |
|
| jclayc |
Sat Jul 06, 2024 7:00 pm |
|
| Ok, ignore the centered part. What about the amount of play side to side? |
|
Powered by phpBB © 2001, 2005 phpBB Group
|