| volksworld |
Fri Jun 03, 2022 6:59 pm |
|
| the top edge of the hole? NOT the passage? what are the measurements? |
|
| volksworld |
Sat Jun 04, 2022 11:27 am |
|
| the recess in the block should be 16mm...this is the OD for the normal "10 mm" seal with the 021 part number...if the recess is 14mm (which i doubt that it is) only then would you need an adapter seal...i've NEVER seen a block cut for 2 different seal sizes but on later blocks the passages themselves are ALWAYS 2 different sizes yet use the same seal |
|
Powered by phpBB © 2001, 2005 phpBB Group
|