| earthquake |
Sat Sep 26, 2015 5:55 pm |
|
I need to put together a motor pretty quick to move a car in a month, I want to use parts I have on the shelf, ok this is what I have...
Dual relief case [type 3]
Revmaster 049 heads [not ported]
AA 94A P&C's
Engle 110 cam [new]
DPR 69mm counterweighted crank
CB Perf 5.4" Uni Tech HD rods
Used steel push rods
stock rockers on solids shafts
40mm Weber IDF's [I have a set of 44's if the 40's are too small]
VW doghouse shroud and all the tin
1 3/8" single QP [I might buy a 1 1/2"]
I need to pick up all the small stuff for the build as I go.
I know the 110 cam is a bit old fashion but I have it on hand, I also have a 30mm oil pump but I might pick up a 26mm instead.
do you guys think it will work and what kinda power do you think it will make? |
|
| Matthew |
Sat Sep 26, 2015 6:35 pm |
|
That's a pretty nice engine just to move a car. What's it going in?
The 26mm oil pump is best and you should have 1 1/2" exhaust with the bigger valves. What size valves are in those heads? |
|
| bugguy1967 |
Sat Sep 26, 2015 6:56 pm |
|
| Oldest combo ever. It'll work together just fine. It should make 110 HP. Those ports are larger than stock, right? |
|
| earthquake |
Sat Sep 26, 2015 8:28 pm |
|
The heads have 40mm intake and 35mm ex.
This motor will be for my 74 class 11 look a like, I had been planing to build a 1914 for awhile but now I have to get it running sooner then I thought I had. I need to find a cheap 1 1/2 exaust system for now. To bad its not a Baja, I have a brand new Tri mil Bobtail on the shelf.
Casey |
|
Powered by phpBB © 2001, 2005 phpBB Group
|