| pupjoint |
Mon Feb 13, 2017 3:27 am |
|
changed this out almost yearly, 2nd time now. is it the quality of the parts or i have been installing wrongly? if not, any good ones out there that doesnt break that fast?
[/i] |
|
| air-h2o-air |
Mon Feb 13, 2017 10:11 pm |
|
| you may get more replies using the correct forum...this is the performance engine-transmission section |
|
| modok |
Mon Feb 13, 2017 11:14 pm |
|
You can get those in urethane or rubber. Same as sway bar links in many cases; just match up the size. IMO it is ok to use urethane in this location but usually I hate it.
Even the cheap ones hold up fine in my experience. Doorman and monroe, ect, ok brands.
I don't know where to buy low quality ones. You tell me. |
|
| Bruce |
Sat Feb 18, 2017 4:59 pm |
|
pupjoint wrote: .... or i have been installing wrongly?
I'd say you are squishing them way too much. |
|
| slalombuggy |
Sun Feb 19, 2017 12:16 am |
|
Bruce wrote: pupjoint wrote: .... or i have been installing wrongly?
I'd say you are squishing them way too much.
X2 far too much, the rubbers should just start to bulge when you tighten the nut down. Stop there
brad |
|
Powered by phpBB © 2001, 2005 phpBB Group
|