| Big Al |
Wed Jun 10, 2020 12:02 pm |
|
What are you guys using for the seals where the two bolts go through the valve cover? I tried to get the originals and was told they are not available.
I used drilled out beveled faucet washers. Anything better?
Al |
|
| jeffrey8164 |
Wed Jun 10, 2020 12:58 pm |
|
| I try not to use anything EMPI so this may not apply but with Bugpack and CB bolt ons I use 887 O-rings and flat washers. Works great. |
|
| Ohio Tom |
Wed Jun 10, 2020 1:06 pm |
|
Engine gasket sets come with O-rings that are the correct size.
Find someone with a leftover kit.
NOt even sure what they were supposed to be for.
I just know that they work. |
|
| Big Al |
Wed Jun 10, 2020 1:17 pm |
|
jeffrey8164 wrote: I try not to use anything EMPI so this may not apply but with Bugpack and CB bolt ons I use 887 O-rings and flat washers. Works great.
I googled 887 O ring and got a 10" O ring:)
What is it?
Al |
|
| jeffrey8164 |
Wed Jun 10, 2020 1:30 pm |
|
| I found them in the sprinkler/irrigation parts at the Deep Homot. |
|
| slalombuggy |
Wed Jun 10, 2020 2:22 pm |
|
| I use case sealing washers on the inside and a rubber backed washer on the outside. |
|
Powered by phpBB © 2001, 2005 phpBB Group
|