| Jim68toad |
Sun May 11, 2025 7:25 pm |
|
Ok you engine guys tell me what I got
Picked up two never used but old as41 cases one say Germany
And the other is Brazil
There are no numbers under the generator mount
|
|
| rugblaster |
Sun May 11, 2025 7:41 pm |
|
| What you have there is a couple of Unicorns. |
|
| Jim68toad |
Sun May 11, 2025 8:00 pm |
|
Are unicorns good or bad
Should I build the Brazil case and save the German
Or dose it matter |
|
| tucson vw |
Sun May 11, 2025 8:25 pm |
|
| It looks like the German case is already bored for 90.5/92mm. |
|
| SBD |
Sun May 11, 2025 9:15 pm |
|
| I think Unicorns are good. :shock: |
|
| Rome |
Mon May 12, 2025 6:01 am |
|
tucson vw wrote: It looks like the German case is already bored for 90.5/92mm.
And that the upper right case saver inserts on both cylinders are standing proud of the cylinder base edge... |
|
| Jim68toad |
Mon May 12, 2025 7:11 am |
|
I’ll measure the cylinder bores to see if there 92mm
I also got a 69mm counter weighted crank so maybe there were going for a 1835 the guys was very old and could remember
They had been in his garage for many years |
|
Powered by phpBB © 2001, 2005 phpBB Group
|