CB Performance steel pushrods - need some info

[Doktor]

Hi,

It's been some time from my last visit on this forum.
I have question about CB Perf. steel pushrods #1626, they are no longer listed in their catalog/website.

For what kind of application can they be used ?

I got them for very good price, unpacked.


Thnx,
Doc
_________________
1970 VW 1300 Bug

[Glenn]

They don't list them on their site.
_________________
Glenn
74 Beetle Specs | 74 Beetle Restoration | 2180cc Engine
"You may not get what you pay for, but you always pay for what you get"

Member #1009

#BlueSquare

עַם יִשְׂרָאֵל חַי

[BFB]

I think he said that, see where he said " they are no longer listed in their catalog" ?

hey OP , why dont you contact C.B. and ask them?
_________________
"how am i supposed to torque the rear wheel nut to 250 ft lbs??? " - clonebug
An interesting thing happens in forums where everyone starts parroting the same thing and "common knowledge" takes over.
Most experts aren't.

[Doktor]

I could, it's not a problem, but usually I can find info much faster here on the forum.
If nobody answers, I will contact CB.
_________________
1970 VW 1300 Bug

[NJ John]

They were cheap “performance” rods. They sold them in a bunch of lengths that helped with flycut or different strokes. I had them and they were loud once the engine got hot.
Are yours assembled or cut to length?
_________________
1973 standard, yellow, lowered, 3” narrowed front, 1600 blo-thru turbo w/single dell 15.4@86, so far
11.41 et buggy. Long gone
Let’s go O’s! Let’s go O’s!
https://www.youtube.com/@AirSpooledGarage

[Doktor]

Cut to length, with blank ends.
_________________
1970 VW 1300 Bug

[Doktor]

I've asked CB about these pushrods.
They said that they can be run with every cam that require std dual valve springs, but not with K800 springs.

So that's it...
_________________
1970 VW 1300 Bug