ECU Multi-Pin Connector

[fixedgear]

The last time I disconnected the ECU I noticed that the crucial #6 connector is squashed. It might still able to make connection with the ECU pin, and I would be able to tell with a voltage check at Temp 1 and Temp2 plugs, but after cutting the harness what is the process to get the connector end out? Also, are the connector ends available and if so, from where? Thanks, Barnaby

_________________
1986 Wolfsburg Weekender

[rubbachicken]

i think you might need a new loom.
are you talking a 2.1 loom, i don't think you'd be able to buy those terminals.
_________________
lucy our westy

lucy's BIG adventure

meet 'burni'

[SL12572]

Hi Barnaby,

I'm converting my fuel injection system and have a harness with that connector I'm willing to sell. If interested, PM me.


Thanks

Scott

[fixedgear]

I may have used the wrong terminology when I referred to "cutting the harness". I meant to say that I was considering cutting the harness protective cover to expose wire to #6 and trying to fish the wire out the front of the multi-pin connector to put a new clip on it. I think however I may be dreaming. Thanks Barnaby
_________________
1986 Wolfsburg Weekender