Best Intake and DP end castings for a 2017 with 34PICT-3

[mark tucker]

I hope your using deep dish piztins to get the low cr. why exzactly do you want low cr? is that even low enough to do whatever it is you want to do?

[frostbite36]

[chrisflstf]

The inlet ID of the CB end pieces is 2". Quite a bit a larger than the stock center section

[frostbite36]

[volksnhousin]

Maybe something like this would work with the CB end castings: https://www.amazon.com/Straight-Reducer-Silicone-Turbo-Coupler/dp/B015N07XOW

I don't know anything about price or availibility but FAT has end castings listed: http://fatperformance.com/Fat_Performance_Parts_Catalog.pdf