Hello! Log in or Register   |  Help  |  Donate  |  Premium Membership  |  Buy Shirts See all banner ads | Advertise on TheSamba.com  
TheSamba.com
 
engle Sc1 cam blank
Forum Index -> Performance/Engines/Transmissions Share: Facebook Twitter
Reply to topic
Print View
Quick sort: Show newest posts on top | Show oldest posts on top View previous topic :: View next topic  
Author Message
PEPPE
Samba Member


Joined: August 24, 2003
Posts: 1072
Location: Roma Italy
PEPPE is offline 
PostPosted: Thu Oct 28, 2010 11:18 am    Post subject: engle Sc1 cam blank Reply with quote
i've been sent an engle 100 that is ground on a SC1 cam blank. i read the older posts but seems that there is no clear answer. is thera a recommended tappet to be used with this cam?
thanks
Back to top
View user's profile Send private message Send e-mail Gallery Classifieds Feedback
DarthWeber
Samba Member


Joined: November 24, 2007
Posts: 7543
Location: Whittier,CA
DarthWeber is offline 
PostPosted: Thu Oct 28, 2010 11:23 am    Post subject: Reply with quote
Try the new Engle lifters.
_________________
Mitey62 wrote:
Swapped the Compufire for a Bosch blue and some points I had sitting around, started 1st crank. Took her out for a drive, pulls harder, more RPM, and runs smoother. I think I'll be sticking with points from now on.

RockCrusher wrote:
JB weld the case halves....that'll keep the fretting to a minimum. Laughing
Back to top
View user's profile Send private message Gallery Classifieds Feedback
PEPPE
Samba Member


Joined: August 24, 2003
Posts: 1072
Location: Roma Italy
PEPPE is offline 
PostPosted: Thu Oct 28, 2010 11:25 am    Post subject: e Reply with quote
are those guaranteed to be good? i 've seen that they now sell "kits". are those kits with those parts?
Back to top
View user's profile Send private message Send e-mail Gallery Classifieds Feedback
DarthWeber
Samba Member


Joined: November 24, 2007
Posts: 7543
Location: Whittier,CA
DarthWeber is offline 
PostPosted: Thu Oct 28, 2010 11:28 am    Post subject: Reply with quote
Engle developed their kits so all parts are compatible and work well together. Follow Engles break in instructions too.
_________________
Mitey62 wrote:
Swapped the Compufire for a Bosch blue and some points I had sitting around, started 1st crank. Took her out for a drive, pulls harder, more RPM, and runs smoother. I think I'll be sticking with points from now on.

RockCrusher wrote:
JB weld the case halves....that'll keep the fretting to a minimum. Laughing
Back to top
View user's profile Send private message Gallery Classifieds Feedback
Display posts from previous:   
Reply to topic    Forum Index -> Performance/Engines/Transmissions All times are Mountain Standard Time/Pacific Daylight Savings Time
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
About | Help! | Advertise | Donate | Premium Membership | Privacy/Terms of Use | Contact Us | Site Map
Copyright © 1996-2025, Everett Barnes. All Rights Reserved.
Not affiliated with or sponsored by Volkswagen of America | Forum powered by phpBB
Links to eBay or other vendor sites may be affiliate links where the site receives compensation.