| Author |
Message |
Ragtop
Samba Member
Joined: November 23, 2003
Posts: 637
Location: Rio Rancho New Mexico
|
 Posted: Fri Jan 26, 2024 8:28 pm Post subject: Swing lever arm |
 |
|
| Anyboby know if the swing lever arm from a spit is the same as an early bay? |
|
| Back to top |
|
 |
sub-hatchtim
Samba Member
Joined: September 19, 2006
Posts: 2670
Location: Phoenix AZ
|
| Posted: Sat Jan 27, 2024 9:49 am Post subject: Re: Swing lever arm |
|
|
It's not
_________________
58' pg/sg silo fridge westy
58 Dove blue singlecab
76 911S |
|
| Back to top |
|
|
Stocknazi
Samba Member
Joined: June 18, 2004
Posts: 5467
|
| Posted: Sat Jan 27, 2024 12:03 pm Post subject: Re: Swing lever arm |
|
|
I believe you are thinking about the Pittman arm for early bay being the same.
They are the same, correct?
_________________
WANTED:
58 Westfalia cabinet knobs (3 needed), roof rack, and (7) privy tent poles (silver painted).
"When the people are afraid of the government, that's tyranny. But when the government is afraid of the people, that's liberty."
"The tree of liberty must be refreshed from time to time with the blood of patriots and tyrants."
Thomas Jefferson
Last edited by Stocknazi on Sun Jan 28, 2024 10:13 am; edited 1 time in total |
|
| Back to top |
|
|
Ragtop
Samba Member
Joined: November 23, 2003
Posts: 637
Location: Rio Rancho New Mexico
|
| Posted: Sun Jan 28, 2024 9:13 am Post subject: Re: Swing lever arm |
|
|
| Stocknazi wrote: |
I believe you are thing about the Pittman arm for early bay being the same.
They are the same, correct? |
I'm talking about the arm that connects to the center pin on the beam and the other end to the drag link. Is it the same on a 69 bay beam to a split beam
Thanks
also just noticed that I put spit not split   |
|
| Back to top |
|
|
Busstom
Samba Member
Joined: November 23, 2014
Posts: 4579
Location: San Jose, CA
|
| Posted: Sun Jan 28, 2024 9:44 am Post subject: Re: Swing lever arm |
|
|
The Bay swing lever has larger holes for the bigger, later rod end tapers.
_________________
My name's Steve and it's pronounced "Bust 'em" (cuz people think I'm Tom)
| cory464 wrote: |
| if you aren't perfectly centered in the hole you will have issues when you tap it. |
|
|
| Back to top |
|
|
Ragtop
Samba Member
Joined: November 23, 2003
Posts: 637
Location: Rio Rancho New Mexico
|
| Posted: Sun Jan 28, 2024 9:38 pm Post subject: Re: Swing lever arm |
|
|
| Busstom wrote: |
| The Bay swing lever has larger holes for the bigger, later rod end tapers. |
Thank you 😊🙏 |
|
| Back to top |
|
|
|
