| Author |
Message |
brandt
Samba Member
Joined: April 27, 2004
Posts: 370
Location: S. Utah
|
 Posted: Sat Jan 28, 2012 6:33 pm Post subject: Cold Start Valve gasket |
 |
|
This might belong in the stupid question thread but,
78 stock F.I.
Getting ready to replace my cold start valve. Does the gasket get installed dry or should I coat it with a bit of something? I have the paper-ish gasket from BD.
Searched Bentley, archives and elsewhere to no avail.
Thanks! |
|
| Back to top |
|
 |
Westfabulous
Samba Member
Joined: January 07, 2007
Posts: 4207
Location: The tropic of Canada, dodging the giant flying moose of Surrey!
|
| Posted: Sat Jan 28, 2012 6:41 pm Post subject: |
|
|
I used a thin cost of Permatex gasket sealant on both sides. I've done this several times on the CSV. Works like a charm.
_________________
*****************
"I will gladly pay you Tuesday for a hamburger today." |
|
| Back to top |
|
|
|
