Author |
Message |
aa390392 Samba Member

Joined: March 28, 2007 Posts: 3601 Location: So.Cal
|
Posted: Sun Jul 10, 2022 1:00 pm Post subject: Rough estimate of finished projects an builds |
|
|
I sat around with a bit of a summer cold,
I was looking at the Subject of Ovals: projects and builds.
To my amazement there’s a lot of unfinished projects sitting in garages…
Or put out to pasture…or hopefully sold.
Note my counts are rough estimates,
I counted approximately 44 B’s or P’s
In which I counted
9 finished cars.
6 sold
30 not finished or died on the vine…
That would mean there’s a lot of projects out there to be had…
Or a source for a lot of Oval parts
Or a lot of misplaced parts fasteners. _________________ .
getting grumpy & less tolerant!
55 ragtop
56 delux sedan
56 Kabriolet |
|
Back to top |
|
 |
lardawge Samba Member
Joined: October 05, 2020 Posts: 419 Location: California
|
Posted: Sun Jul 10, 2022 2:55 pm Post subject: Re: Rough estimate of finished projects an builds |
|
|
Finishing a restoration is hard. It gets harder the higher level you try to achieve. I am battling one myself and stuck trying to get metal work and paint. It takes the wind out of your sails big time. I continue to chip away at it but can’t see the finish line. I have contemplated selling it because it is so mentally taxing. _________________ 11/2/54 L227 Strato Silver Ragtop - Build Thread
1/7/55 L275 Light Beige - Build Thread
9/1/56 (57 model) L331 Horizon Blue - For Sale |
|
Back to top |
|
 |
52 split Samba Member
Joined: December 19, 2007 Posts: 162 Location: the best island in the world, vancouver island
|
Posted: Sun Jul 10, 2022 5:10 pm Post subject: Re: Rough estimate of finished projects an builds |
|
|
well mines been on the rotisserie for four years. 96 percent done. higher level yes, anyone can build a custom, correct engine, panels and fasteners take a toll. current time on this ten years not a oval but a split. sure many sitting in shops but none for sale, cause most say, I'm going to get on it one day. |
|
Back to top |
|
 |
txoval Samba Member
Joined: January 23, 2004 Posts: 3864 Location: The Woodlands, TX
|
Posted: Sun Jul 10, 2022 5:57 pm Post subject: Re: Rough estimate of finished projects an builds |
|
|
Are you asking for an estimate?
Granted, it depends on the condition of the car, but if you’re going to strip it completely down, your looking at $20k in panels/metal work/paint and another $20k to finish
If you do more yourself, the cost obviously comes down.
This doesn’t include the original purchase price…
This hobby isn’t about making money… |
|
Back to top |
|
 |
aa390392 Samba Member

Joined: March 28, 2007 Posts: 3601 Location: So.Cal
|
Posted: Sun Jul 10, 2022 7:03 pm Post subject: Re: Rough estimate of finished projects an builds |
|
|
Good points Tex
Lard, I see you purchase aftermarket fenders, howd they line up?
What year oval are you wrenching on?
Im on my 3rd Oval, now reassemble begings.
Slow and methodical ...at times frustrating...but better than a game of golf...fishing bowling..
55's can be strange birds.
. _________________ .
getting grumpy & less tolerant!
55 ragtop
56 delux sedan
56 Kabriolet |
|
Back to top |
|
 |
lardawge Samba Member
Joined: October 05, 2020 Posts: 419 Location: California
|
Posted: Sun Jul 10, 2022 8:06 pm Post subject: Re: Rough estimate of finished projects an builds |
|
|
aa390392 wrote: |
Lard, I see you purchase aftermarket fenders, howd they line up?
What year oval are you wrenching on?
|
I did buy a set of Klassic Fab fenders. They kind of line up but will need a bunch of work. I am not using them on my project. Opted to use the originals.
Mine is the 55 in my sig. Its basically a 54. Going all stock. Chassis work has been completed. Powder coated and replaced pan halves. All original hardware plated black zinc. Front end powder coated and plated. Transaxle rebuilt and motor built. Just need to assemble as a roller. Frustratingly stuck on metal work. Everyone is backed up for years. Haven’t even though about who will paint it. _________________ 11/2/54 L227 Strato Silver Ragtop - Build Thread
1/7/55 L275 Light Beige - Build Thread
9/1/56 (57 model) L331 Horizon Blue - For Sale |
|
Back to top |
|
 |
RustPatch Samba Member

Joined: August 07, 2007 Posts: 139 Location: Maple Ridge BC Canada
|
Posted: Mon Jul 11, 2022 3:31 pm Post subject: Re: Rough estimate of finished projects an builds |
|
|
Make that 31 not finished as my oval is in year 10 of restoration and I don't have a build thread on here. |
|
Back to top |
|
 |
aa390392 Samba Member

Joined: March 28, 2007 Posts: 3601 Location: So.Cal
|
Posted: Mon Jul 11, 2022 5:30 pm Post subject: Re: Rough estimate of finished projects an builds |
|
|
Lots of folks haven’t returned to TS. So knowledge of there build will remain a mystery…
some are stuck in a much needed garage, taking up much needed space…with metal shaving from the project in the daily laundry from washer an dryer sharing that space.with boxes being stacked on that dream. _________________ .
getting grumpy & less tolerant!
55 ragtop
56 delux sedan
56 Kabriolet |
|
Back to top |
|
 |
banana split Samba Member

Joined: January 22, 2002 Posts: 1130 Location: Beautiful British Columbia Canada
|
Posted: Tue Jul 12, 2022 10:49 am Post subject: Re: Rough estimate of finished projects an builds |
|
|
These cars are easy to tear apart... 10x harder to put back together again  _________________ My Beetles :
1951 Crotch Cooler 11G Split Ragtop
1953 Zwitter
1964 Chop Top |
|
Back to top |
|
 |
56Cabrio Samba Member

Joined: May 22, 2008 Posts: 2065 Location: San Fernando Valley, CA
|
|
Back to top |
|
 |
VW_Jimbo  Samba Member

Joined: May 22, 2016 Posts: 11317 Location: Huntington Beach, CA
|
Posted: Tue Jul 12, 2022 11:02 pm Post subject: Re: Rough estimate of finished projects an builds |
|
|
56Cabrio wrote: |
banana split wrote: |
These cars are easy to tear apart... 10x harder to put back together again  |
X2 I'll co-sign that !!! |
But just like everything else in life, the more times you do a task, the easier it gets! I am on restoration number 5. Next one up is the FIL’s 57 Bel Air! Got to finish the 54 first! _________________ Jimbo
There is never enough time to do it right the first time, but all the time necessary the second time!
TDCTDI wrote: |
Basically, a whole bunch of fuckery to achieve a look. |
67rustavenger wrote: |
GFY's Xevin and VW_Jimbo!  |
|
|
Back to top |
|
 |
2Dokas Samba Member
Joined: October 09, 2004 Posts: 758 Location: Santa Cruz, CA
|
Posted: Wed Jul 13, 2022 7:12 pm Post subject: Re: Rough estimate of finished projects an builds |
|
|
banana split wrote: |
These cars are easy to tear apart... 10x harder to put back together again  |
only 10X?
I took the glass out of my convertible quarter panel window frames in less than 30 minutes. I have at least 4 hrs into one of them and they are still in 2 pieces. _________________ 87 Doka 2WD Ej22,
56 Convertible |
|
Back to top |
|
 |
|