| Author |
Message |
mbjeeper
Samba Member
Joined: October 13, 2003
Posts: 159
|
 Posted: Wed Dec 18, 2019 9:54 am Post subject: Metal sunroof headliner panel steel clip -where can I get some? |
 |
|
I have been looking everywhere I can think of for the metal 'V' looking clip that holds the metal sliding sunroof's headliner shell in place. There are several of them that install into the front of the metal piece that the headliner adheres to, and they hold the headliner panel to the sunroof panel itself.
I am missing a few of them and I cannot seem to find a source for them anywhere.
They are a V shaped metal clip, about 1/4" wide by about 1/2" deep.
If anyone knows of a source for these clips, or has some extras, I'd love to hear from you.
Thanks
Greg |
|
| Back to top |
|
 |
Tim Donahoe
Samba Member
Joined: December 08, 2012
Posts: 11812
Location: Redding, CA
|
| Posted: Wed Dec 18, 2019 2:44 pm Post subject: Re: Metal sunroof headliner panel steel clip -where can I get some? |
|
|
Put in a WTB (want to buy) ad in the Samba Classifieds. Parts, Type One Bug 1968 and Up.
Tim
_________________
Let's do the Time Warp again!
Richard O'Brien |
|
| Back to top |
|
|
VW_Jimbo 
Samba Member
Joined: May 22, 2016
Posts: 11491
Location: Huntington Beach, CA
|
| Posted: Wed Dec 18, 2019 3:20 pm Post subject: Re: Metal sunroof headliner panel steel clip -where can I get some? |
|
|
I used an early Bug moulding clip. Worked fine. You will need to take the bends out of the part that rests against the panel.
_________________
Jimbo
There is never enough time to do it right the first time, but all the time necessary the second time!
| TDCTDI wrote: |
| Basically, a whole bunch of fuckery to achieve a look. |
| 67rustavenger wrote: |
GFY's Xevin and VW_Jimbo!  |
|
|
| Back to top |
|
|
|
