SKF codes for front and rear grease seals and bearings?

[Komissar]

Hello,

I am in the process of replacing my wheel bearings front and rear (for good measure) - 1972 Variant.

Does anybody have the SKF codes (or FAG) for the rear (inner and outer) and front grease seals ? And for the rubber o-ring that sits in the rear bearing housing/cover.
And also the SKF codes for the bearings themselves.

So far from what I have compounded from the bearing list here on thesamba are VW and FAG codes for the bearings, but it would seem that the local bearing suppliers from where I live cannot find those, they usually work with SKF codes.

Thanks in advance.

Lawrence


Also: for the rear bearing inner the chart on thesamba gives the following code: 6206 TNH.C3 - one supplier has a 6206 C3 SKF - are these two the same thing?
_________________
1965 Sunroof Beetle
1972 Type 3 Squareback
1978 Skoda 105S

[Erik G]

ok, double check my work but I think this is right

http://www.showmetheparts.com/timken/

Timken says the outers (bearing AND race) is SET1 inners are SET8

SKF conversion shows that as BR1 and BR8

http://www.skf.com/binary/79-66347/457013.pdf

timken has the seals as 1195. I didn't see a conversion for that

best luck
_________________
Stop dead photo links! Post your photos to The Samba Gallery!

[Komissar]