Bobnotch
Samba Member
Joined: July 06, 2003
Posts: 23371
Location: Kimball, Mi
|
 Posted: Fri Aug 01, 2025 10:42 am Post subject: Re: Type 3 wireing harness |
 |
|
| dersy wrote: |
| Hello. I need to know how to route the wireing harness through the car. |
For 66 on (prior to 66, the harness ran thru the left heater channel assembly), if you're meaning the main front (fuse box) to rear, most of it runs along side in the channel under the left door, then pops out near the voltage regulator, then goes up and over the inner fender well then to both the left rear tail light and thru a hole at the front of the engine compartment. From there it runs across the front of the engine compartment to the right side and pops out a hole to the right rear tail light.
In the 72-73 models the wiring harness continues on the inside under the rear seat cushion thru a hole into the engine compartment then splits to both rear tail lights. I hope this helps.
_________________
Bob 65 Notch S with Sunroof
71 Notch ...aka Krunchy; build pics here;
http://www.thesamba.com/vw/forum/viewtopic.php?t=249390 -been busy working
64 T-34 Ghia...aka Wolfie, under construction... http://www.thesamba.com/vw/forum/viewtopic.php?t=412120
| Tram wrote: |
| "Friends are God's way of apologizing for relatives." |
| Tram wrote: |
| People keep confusing "restored" and "restroyed". |
|
|
