| Author |
Message |
Bashr52
Samba Member
Joined: July 16, 2006
Posts: 5669
Location: On an island in VA
|
 Posted: Thu Jun 18, 2009 7:24 am Post subject: This doesnt sound right (deck height) |
 |
|
| I bought what I was told were 92B's for my 2234 project. I'm in the mockup stages now, and I have a .155 inch over hang from the pistons. Sounds to me like these are really A's no? |
|
| Back to top |
|
 |
turboblue
Samba Member
Joined: October 09, 2003
Posts: 4216
Location: Central Indiana
|
| Posted: Thu Jun 18, 2009 7:37 am Post subject: |
|
|
Not really.
84 stroke takes a pretty healthy shim pack.
Is your case decked as well?
_________________
Gary
Turbo VW Sand Drag Buggy
"If you don't run into the Devil every once in awhile, you must be going in the same direction!" |
|
| Back to top |
|
|
The Noof
Samba Member
Joined: January 25, 2005
Posts: 4346
|
| Posted: Thu Jun 18, 2009 7:42 am Post subject: |
|
|
| Sounds about right to me, especially if the case registers have been cleaned up. |
|
| Back to top |
|
|
miniman82
Samba Swamp Donkey
Joined: March 22, 2005
Posts: 9515
Location: Southern Maryland
|
|
| Back to top |
|
|
nsracing
Samba Member
Joined: November 16, 2003
Posts: 9744
Location: NOVA
|
| Posted: Thu Jun 18, 2009 2:25 pm Post subject: Re: This doesnt sound right (deck height) |
|
|
| Bashr52 wrote: |
| I bought what I was told were 92B's for my 2234 project. I'm in the mockup stages now, and I have a .155 inch over hang from the pistons. Sounds to me like these are really A's no? |
Only that much overhang? It is not a drop-in huh, Bash? 
How long are the rods you using?
Just push the cylinder up to the deck you desire then measure the deck space below the cylinder. Mock up some shims together and see where the final deck figure is. Then find or have the proper spacers made.
They make really long cylinder barrels and just trim for whatever height you need. These cylinders are really usefull when you go to the 88mm strokes and 6-inch rods. Talk about a wide engine block. |
|
| Back to top |
|
|
Bashr52
Samba Member
Joined: July 16, 2006
Posts: 5669
Location: On an island in VA
|
| Posted: Fri Jun 19, 2009 11:09 am Post subject: |
|
|
Ok just checking. These cylinders were run on a stroker briefly before, and the tops of the pistons were machined slightly to help with deck. I guess I'm giving RIMCO or someone a call with the shim dimensions... Mabie I'll give the local machine shop a call as well.
Rods are 5.5 chevy. |
|
| Back to top |
|
|
|
