Making progress with the Type 1 in my 356 - help with throttle?

[dpetteng]

So, my theory for doing all this is that I can still have fun in my 356 with a type 1 in it while doing a cosmetic refresh of my 356 engine!

Got a new built type 1 engine with CSP Porsche cooling and this weekend got it in the car. The clutch and flywheel seem fine. Already got a 12v starter with 6v cog but the biggest challenges are tinware which I am working on and the throttle linkage as you need to adapt the stiff rod coming from the 356 pedal to a cable driven CSP throttle linkage. Any ideas?

[[email protected]]

Since you are not getting much info on here on your post ..you should try posting on the "kit car 356 replicas" fourm " you probably get more help on there ...

[Starbucket]

Your problem is the stock cable is too short so you have two choices, 1, Get a cable clamp and a short piece of cable to reach the single carb. and clamp it behind the shroud. 2 Buy a VW cable and use it while you are rebuilding your motor.

[wagen19]

[dpetteng]

So the problem is that the 356 had a stiff rod driven throttle and the type 1 engine has a cable driven setup. I am using the CSP porsche cooling setup. CSP throttle bellcrank and twin IDF 40 carbs

[Starbucket]

Have you installed the motor yet? If the bell crank mounts behind the shroud like Porsche does I'm not sure what the problem is you should be able to connect the rod to the bell crank.

[dpetteng]

engine has been in once for tinware fitting but next time it is in I will take pics to show the problem

[Starbucket]

Another thought, use the original Porsche linkage by mounting it to your new should.

[dpetteng]

I would love to do that but I am using porsche csp cooling on the replacement engine so nowhere t mount the bracket to

[wagen19]