Hello! Log in or Register   |  Help  |  Donate  |  Buy Shirts  See all banner ads | Advertise on TheSamba.com  
Classifieds Index -> Vendors - New Parts -> High Performance/Engine
Super Duty Bus Axles into IRS Bug Kit For Type 1 Turn on always show all large photos     Ad id: 2085468
Super Duty Bus Axles into IRS Bug Kit For Type 1   Price: 599.95
This kit converts your Type 1 IRS rear drive axle to the larger and much stronger Bus components, as used in the '73 and '74 VW Thing. This kit is commonly used in street or strip cars with high output motors and off-road cars that take a beating! All components simply bolt right in to complete your conversion. We have used and tested this same kit in our own drag cars and off road cars and never had a single failure. CV joints are factory rated for 17 degrees of travel, but we have successfully run them up to 22 degrees!

All components are included to complete the conversion:

(2) Forged 100mm stub axles

(2) Forged 100mm Type 1 trans drive flanges

(2) Axles complete with 100mm CV's, axle boots, axle shafts, retainer clips... even the Moly CV grease!

(24) Hardened aircraft quality CV bolts

(12) 100mm torque distribution washers

This kit only works with Type 1 transmissions. If you have a 002 or 091 bus box, you'll need to order the IRS-2 kit. As with any forged axle component, we recommend using a torque wrench to properly torque all fasteners. Do not use a pneumatic impact, cheater bar, or axle nut beater tool!

Order here:


Kaddie Shack -- High quality parts for air-cooled VW's. -- COME VISIT OUR RETAIL STORE AT 1609 WALNUT ST. IN PASADENA! -- We carry a complete line of quality parts and back it up with great service and help.

Kaddie Shack 5 minute YouTube Tour:

Our phone# is 714-752-3766, email: [email protected].
Open M-F 10AM to 7PM

All of our Kadron carburetors and SVDA distributors come with a 90 day warranty & free tech service help. We want happy customers & repeat business. We specialize in Kadrons, & can rebuild, re-bush, and modify yours for use with any engine. They'll be BETTER THAN NEW when we're done with them.

Performance engines and front beams built to order - In-house dyno.
Advertiser information Ad information
Member since:
57baja Premium Membership
Jeff's Kaddie Shack
April 15, 2008
Contact advertiser

Phone: Click to Show

Email this Advertiser
Email this Advertiser
Ad placed: 
Ad renewed: 
Ad last edited: 
Payments accepted: 
Pasadena, California, USA Map it
Wed Aug 16, 2017 1:31 pm
Wed Sep 08, 2021 11:33 am
Mon Sep 13, 2021 2:45 pm
Vendors - New Parts - High Performance/Engine
Money order/Bank check
Personal check

View other ads View profile Search for Feedback Watch this ad | Report this Ad
Watch this seller Share: Email Facebook Twitter
Other ads from 57baja
See all | See ads in this category
Thing Stub Axles (Type 2 or 4 CV's) NEW
Thing Stub Axles (Type 2 or 4 CV's) NEW
Drop Lowered Spindles forLink Pin Front End
Drop Lowered Spindles forLink Pin Front End
NEW Kadron Solex EMPI H40/44EIS Dual Carbs w/mods
NEW Kadron Solex EMPI H40/44EIS Dual Carbs w/mods
NEW Scat 1:25:1 Ratio Rockers
NEW Scat 1:25:1 Ratio Rockers
Rebushed Kadron Throttle Bodies
Rebushed Kadron Throttle Bodies

About | Help | Advertise | Donate | Premium Membership | Privacy/Terms of Use | Contact Us | Site Map
Copyright © 1996-2020, Everett Barnes. All Rights Reserved.
Not affiliated with or sponsored by Volkswagen of America | Forum powered by phpBB