Using Oil Relief for Full Flow

[mkbug]

I just saw this setup and wondered if it would be a good solution for cases that are not drilled for full flow.

https://carcraftstore.com/boltonoilcoolerfankit.aspx

If this has been discussed before please direct me to that discussion. My searching didnt turn up anything.
_________________
I'm Martin


My Build: https://www.thesamba.com/vw/forum/viewtopic.php?t=667183

[Glenn]

Looks like it remove the spring and piston, so how does that effect the stock oil cooler bypass?

I think you're better off with and in/out oil pump.

_________________
Glenn
74 Beetle Specs | 74 Beetle Restoration | 2180cc Engine
"You may not get what you pay for, but you always pay for what you get"

Member #1009

#BlueSquare

עַם יִשְׂרָאֵל חַי

[mkbug]

[quote="Glenn"]Looks like it remove the spring and piston, so how does that effect the stock oil cooler bypass?


It looks like there is a spring and piston in the picture - lower left corner.
How would the oil flow past the piston? This is confusing.
_________________
I'm Martin


My Build: https://www.thesamba.com/vw/forum/viewtopic.php?t=667183

[k@rlos]

The hopped up 1600 in my 1960 bug uses that method and it runs great. Oil pressure & temps are spot on