| Author |
Message |
turbo12v
Samba Member
Joined: January 14, 2007
Posts: 23
Location: New Jersey
|
 Posted: Sun Mar 11, 2007 6:24 pm Post subject: need info on windshield visor |
 |
|
| I need to know if there is a place I can get a windshield visor for my 79 bus |
|
| Back to top |
|
 |
steponmebbbboom
Samba Member
Joined: May 01, 2004
Posts: 6390
|
| Posted: Sun Mar 11, 2007 6:56 pm Post subject: |
|
|
| you mean the aussie ones? |
|
| Back to top |
|
|
4Doora
Samba Member
Joined: November 13, 2006
Posts: 1154
Location: Hudson, NH
|
| Posted: Sun Mar 11, 2007 8:02 pm Post subject: |
|
|
I've been looking into a visor too, but can't seem to find a place to buy one new.
They have them on cip1.com, but $300 is a little steep, considering it's the plastic version, opposed to the Australian mesh version 
_________________
'69 Bug,'71 Bus,'61 Bug ,'56 Bug, '66 Panel |
|
| Back to top |
|
|
karmann57
Samba Member
Joined: October 22, 2004
Posts: 705
Location: Airdrie, Alberta
|
| Posted: Sun Mar 11, 2007 8:53 pm Post subject: |
|
|
I looked quick and don't see the baywindow visor anymore on cip1.com. I know you can get them from Karmann Konnection in England but it's the plastic version and would likely cost more than $300 to get here.
Shane |
|
| Back to top |
|
|
4Doora
Samba Member
Joined: November 13, 2006
Posts: 1154
Location: Hudson, NH
|
|
| Back to top |
|
|
jmstu76
Samba Member
Joined: March 01, 2004
Posts: 1280
Location: Edmond Oklahoma
|
| Posted: Mon Mar 12, 2007 12:58 pm Post subject: |
|
|
That would be pretty cool, but $300 plus shipping is a bit steep. I'm not saying you can get them cheaper anywhere else, just saying it's a lot of cash.
Does anyone have a picture of a Westy with a visor on it?
_________________
James
'76 Deluxe Sage Green Westy
2258 cc GD case 78mm CW crank, 2.0 H-beam rods 5,325” 22mm pin, JE forged pistons with 15cc dish, JE rings, type 11 clearanced oil pump, CB Eagle 2205 Type-2 “Torque Special” hydraulic cam with matched lifters fed by CB Dual Weber 40 IDF MX with 6” foam air filters, currently 55 idle, 130 main, 200 air correction, 32 mm venturis. 27in General Grabber AT2 All Terrains, Berg Shifter, stock '76 exhaust HPC Ceramic Coated. 11/18/2020 |
|
| Back to top |
|
|
bayinthevdub
Samba Member
Joined: January 27, 2011
Posts: 42
Location: Vancouver, WA
|
| Posted: Mon Mar 28, 2011 6:50 pm Post subject: |
|
|
damn they look nice but yah, that's a pretty penny. I can get a rear safari for that. Maybe down the road a bit. pretty slick
_________________
78 green kombi(finally looked my vin up) |
|
| Back to top |
|
|
|
